puntomk2.MyForum.ro

EastUpperGooner · Junior Joined: 12 Feb 2011 Posts: 4

Not exactly the hardset job in the world but maybe useful to someone.

Tools needed

- 10mm socket and ratchet
- Phillips head screwdriver

Process

Push the sunroof switch panel to the drivers side and unclip it. It's only clipped in on the passenger side so it needs compressed to be removed:

How to : Fit an aerial and base to a model with a sunroof How to : Fit an aerial and base to a tip with a sunroof

How to : Fit an aerial and base to a model with a sunroof How to : Fit an aerial and base to a tip with a sunroof

Unclip wiring.

Looking at the motor there are 3 gold screws holding it in place, undo them. Slide the motor down and out of the hole where the switch panel was. Just let it dangle down as there's no point unclipping the wiring as you just have to put it back anyway...

How to : Fit an aerial and base to a model with a sunroof How to : Fit an aerial and base to a tip with a sunroof

Undo the 10mm nut and bolt holding the base in place. Go outside and remove the base. Re-fit new base and put the nut/bolt on nip-tight. Fit the aerial and check it's all square (mine isn't in the pic).

How to : Fit an aerial and base to a model with a sunroof How to : Fit an aerial and base to a tip with a sunroof

Tighten the nut/bolt up inside the car. Re-fit everything that's been removed.

Job done, easy 10 min job.