Jokerman170
Administrator
Joined: 12 Feb 2011
Posts: 16
|
 Posted: 12/02/2011 22:01 Post subject: Guide : HGT- Oil Change |
 |
|
This should be done every 6 months or 6k, which ever comes first. Keep the level topped up to the max, check it weekly. If you run it low its a time bomb as to when it'll throw a rod. They do use oil so don't be too concerned if its dropping slightly.
First stick some flush in the oil and run it as per the instructions (this is optional).
Next leave the oil cap off so the oil drains quicker,
While the oil is still warm undo the sump bolt (8mm allen key), You can see it in the pic to the left of the exhaust
Place a suitable container under it to catch the oil (bear in mind it holds 4.1ltrs)
While its draining you can change the copper washer, or if your tight like me you can simply heat the washer up untill its cherry red with a blow torch and dip it straight into water, it will then be like new (this process is called annealing you will notice the copper is bendy again and not rock hard)
Clean up the face of the sump where the sump bolt goes in and stick the bolt back in (do not over tighten as its only ally your going into)
Next remove the oil filter, you should be able to undo it by hand, otherwise you can use a proper removal tool or at worst stick a big screwdriver through it. You'll probaly get more oil coming out so keep the container handy
Once its removed clean up the face with a cloth etc
Before refitting the new oil filter stick a bit of new oil in it and rub some oil around the rubber seal, this avoids an air lock and guarentees a good seal
Screw the new oil filter on, its a bit of a funny angle so can be a bit fiddley, Its needs to be hand tight, if your a bit weak get a beefcake mate to do it
Finally fill it up with oil, it takes 4.1 ltrs so stick 4 in at first
After 10 mins check the level and top up as neccesary, check for leaks, make sure the caps on, job done:driver: |
|
Log in to check your private messages
Log in
Register
